Fein ASCM12 Serie Instrucciones De Uso página 19

OBJ_BUCH-0000000367-001.book Page 19 Thursday, February 14, 2019 2:50 PM
Setting the operating mode
(ASCM12 (**)) (figure 10).
Set the desired operating mode.
For drilling, adjust the torque setting to the
"drilling" symbol.
Selecting the rotation direction
(figure 11).
To avoid accidental starting, e. g., during
transport, set the rotation selector switch to
the centre position.
Set the rotation selector switch to right or left
rotation as required.
Adjust the rotation selector switch only
when the machine is at a complete stop.
Adjusting the gear setting
(ABSU12 (**), ABSU12W4 (**))
(figure 12).
Adjust gear setting 1 to work with low speed
and high torque. This gear setting is suitable
for drilling with large drill bit diameters.
Adjust gear setting 2 to work with high speed
and a lower torque. This setting is suitable for
drilling with small drill bit diameters.
The material-dependent gear setting can be
determined by practical testing.
Adjust the rotation direction only when
the machine is at a complete stop.
Fig. 10
Fig. 11
Rotational direction switch
Fig. 12
Gear selector
en
19