Setting Up The Network Information Of The Camera - Sanyo VCC-HD4000P Manual De Instrucciones

Setting up the network information of the camera

<Default Settings>
• DHCP : OFF
• IP Address : 192.168.0.2
• Subnet Mask : 255.255.255.0
• Gateway : 192.168.0.1
If you wish to use the default settings, the settings below are not necessary.
1
Select [NETWORK SET] with the jl
buttons and press the SET button.
DHCP
IP ADDRESS
SUBNETMASK
GATEWAY
NETWORK SPEED
PORT
DEFAULT
[MENU]_(MAIN MENU)
2
Select [DHCP] with the jl buttons and
press the SET button.
• appears next to the selection "OFF"
indicating that you can change the
setting.
DHCP
IP ADDRESS
SUBNETMASK
GATEWAY
Select "OFF" or "ON" with the jl
buttons and press the SET button.
OFF: Manual setting (go to step 3)
ON: Automatic setting (go to step 5)
3
Select [IP ADDRESS] with the jl
buttons and press the SET button.
IP ADDRESS
IP ADDRESS
192.168.000.002
x
Select the input position with the dc
buttons, select a value with the jl
buttons, and press the SET button.
4 Use the same procedure as in step 2 to
set up [SUBNETMASK] and [GATEWAY].
OFF
SET y
SET y
SET y
NO LIMIT
00080
OFF
OFF
SET y
SET y
SET y
• Network Speed
(bandwidth limitation) : NO LIMIT
• Port Number
5
Select [NETWORK SPEED] with the jl
buttons and press the SET button.
• appears next to the selection "NO
LIMIT" indicating that you can change the
setting.
DHCP
IP ADDRESS
SUBNETMASK
GATEWAY
NETWORK SPEED
PORT
DEFAULT
[MENU]_(MAIN MENU)
Select the network speed (bandwidth
limitation) with the jl buttons and
press the SET button.
NO LIMIT, 128, 256, 512 (Kbps), 1, 2, 3, 4,
5, 6 (Mbps)
6
Select [PORT] with the jl buttons and
press the SET button.
PORT
[MENU]_(NETWORK)
Select the input position with the dc
buttons, select a value with the jl
buttons, and press the SET button.
7
Press the MENU button to exit the
settings.
15
: 80
OFF
SET y
SET y
SET y
NO LIMIT
00080
OFF
PORT
00080
x