Yamaha AVENTAGE CX-A5200 Guía De Inicio Rápida página 10

2
Connecting a power amplifier, speakers and
subwoofers
Refer to the connection diagram shown on the next page.
1
Connect the PRE OUT jack of the unit to the main
input jack of the power amplifier for each of 11
channels (1 or 2).
When making balanced connections (1), connect PRE OUT (XLR) jacks
of the unit to the main input (XLR) jacks of the amplifier with XLR
balanced cables.
When making unbalanced connections (2), connect PRE OUT (RCA)
jacks of the unit to the main input (RCA) jacks of the amplifier with audio
pin cables (RCA unbalanced cables).
2
Connect the subwoofers (with built-in amplifier) to
the SUBWOOFER PRE OUT 1–2 jacks (1 or 2).
3
Connect each speaker to the corresponding
speaker terminal of the power amplifier.
For details on speaker connections, refer to the instruction manuals for
your power amplifier and speakers.
Note
• You can connect 2 subwoofers to the unit and place them on the right/left (or front/
rear) sides of the room. When using 2 subwoofers, configure the "Configuration
(Subwoofer)" setting after connecting the power cable to an AC wall outlet. For
details, refer to the Owner's Manual.
• If you have a Yamaha power amplifier that supports the trigger function (such as
MX-A5200), you can control the power amplifier in conjunction with operating the unit
(such as powering on/off) by making a system connection. For details, refer to the
Owner's Manual.
10
En
• Use a subwoofer equipped with built-in amplifier.
• Before connecting a power amplifier and subwoofers to the unit,
remove the power cables of the unit, power amplifier and subwoofers
from the AC wall outlets.
• The pin assignments for the XLR output jacks of the unit are shown
below. Before connecting an XLR balanced cable, refer to the
instruction manual of your device and verify that its XLR jacks are
compatible with the pin assignments.
XLR output jacks
1. GND
3. COLD
2. HOT