Descargar Imprimir esta página

Bimar YDZ-10D/3 Manual De Instrucciones página 38

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

they have been evacuated to an acceptable level to make
certain that flammable refrigerant does not remain within the
lubricant. The evacuation process shall be carried out prior to
returning the compressor to the suppliers. Only electric heating
to the compressor body shall be employed to accelerate this
process.
When oil is drained from a system, it shall be carried out safely.
INSTALLATION
 After removing the packaging, check that the appliance is intact; if in doubt, do not
use it and contact a qualified professional. Packaging components (plastic bags,
polystyrene, metal staples, etc.) must not be left within reach of children or persons
with diminished responsibility, since they are potentially hazardous; they must be
disposed of in accordance with the current law.
 Before connecting the appliance, check that the data plate (voltage, etc.) are the
same as those of your mains electricity supply. This appliance must be connected to
a socket that has an effective earthing device (the manufacturer declines any
liability that may arise from failure to comply with this rule). Check that no other
appliances with a high energy consumption are connected to the power supply, to
avoid overloading and the risk of fire. In general, the use of adapters, multiple
sockets and/or extension leads is not recommended. If their use is unavoidable,
they must comply with current safety regulations and their current capacity (amps)
must be no lower than the maximum current draw of the appliance.
 The appliance must be installed and/or placed in a location with a surface area of at
least 2m².
 Do not install the dehumidifier in environments where there are flammable
products (spray cans or canisters containing gas, liquids or solids), or in dusty
environments.
 Place the appliance: away from sources
of
heat,
keep
(curtains, hanging laundry, etc.) or
anything else that might come into
contact and/or obstruct the inlet and
outlet grilles; keep away from bathtubs,
sinks or similar, to avoid the appliance
being splashed with water, or falling into
these.
 Ensure there is a free space around the
appliance of at least 50 cm.
away
from
fabrics

Publicidad

loading