Bimar YDZ-10D/3 Manual De Instrucciones página 40

On/Off Turns on the appliance and puts on standby. The fan starts up
Button
after a few moments and then the compressor starts up (if
necessary).
Mode Selects Automatic or Continuous dehumidifying (dry laundry
Button
function): only works when the appliance is switched on. When
the the mode is selected, the corresponding LED light flashes.
Select the relative humidity button (HR%). The function only
Humidity
works when on "Auto" mode. Press the button to select 30 to 80
Button
HR% (the pre-set value is 50%): each time it is pressed, it
increases by 5%. The value can be viewed on the display, which
after a few moments shows the current value.
Fan Button
Select the fan: "High" or "Low".
Inside This activates internal drying and the drying of the frost that can
Drying
form on the evaporation coil. The display shows " CL " and the
Button
"inside drying" LED light flashes. The process lasts for
approximately one hour, and no other function can be used. To
stop the drying, press the button again or press "On".
Timer This times the appliance operation or start-up: each time the
Button
button is pressed, the time increases by one hour, up to a
maximum of 24 hours. If pressed again, the time is cancelled.
To time the operation, turn on the appliance, set the humidity
level, the fan and the mode, then set the timer to the desired
time (1-24h): the appliance will turn off after the time set on the
timer is finished.
To delay start-up, press the button until the required time is
reached (1-24h), then set the mode, fan and humidity level. The
appliance will start up after the time set on the timer.
Display View time (hours) and humidity (%)
Tank gauge
Indicates that the tank is full.