3. Turn on the appliance by pressing
the instructions above.
4. When removing the tank, the dehumidifier will stop the compressor and after
approximately 3 minutes the fan will stop: the appliance is now on standby. Once
it is back in place, the appliance will automatically start in a few moments.
5. To deactivate the appliance, press the
completely, remove the plug from the power socket.
6. Except when ventilating the environment, keep windows and doors closed, to
maximise the effects of the dehumidifier.
During long periods of inactivity, remove the plug from the electric socket.
CLEANING AND MAINTENANCE
Warning: disconnect the plug from the power socket before routine cleaning. Keep
the appliance in an upright position during cleaning.
Filter
It is advisable to clean the filter periodically (approximately
every two weeks max. or more often if the appliance is used
daily).
Remove the tank, slide the filter downwards and remove it.
When cleaning the filter, only use lukewarm water. Do not
use hot water, detergents, solvents, abrasives or similar. Dry
thoroughly (do not use hot air) and then replace it correctly
into position.
Tank
It is advisable to empty it after every use and wash it periodically to avoid the
formation of bacteria or unpleasant smells. To clean the tank, use lukewarm water
with a regular detergent for crockery (do not use abrasives, solvents or similar),
wash it and replace it into position.
Main Unit
Wash only with a soft cloth dampened with water.
When not in use for long periods, empty the water from the tank, wind the cable
around the cord winder, store in an upright position, away from dust and humidity,
and respecting the precautions set out in the warnings section.
If you decide not to use the appliance any more, it must be rendered unusable by
cutting off the power-supply cord (first making sure that the plug has been removed
from the power socket), and any parts which are hazardous if used as children's
playthings must be rendered harmless.
Gas R290
Please be reminded to follow the instructions in the warnings section.
and activate the desired function, following
button. Go to standby and to switch it off