Cleaning And Maintenance - Sinbo SS 4028 Manual Del Usuario

HOW TO USE PRODUCT
make sure the comb accessories have already fix on slot both sides in true
ways (Fig 19).
3. The comb accessories have two length "3MM" and "6MM" for clip hair with
different length.Replacing the comb accessories direction according to length
mark in the bottom (Fig 20). Put down the comb accessories from one side
slot to another(Fig21 ).
4. Open the switch, use it above hair slowly. For good clip effect, please use
the product in the differenct direction from hair growth direction.

CLEANING AND MAINTENANCE

1. Take out the hair clipper head, use brush to clean the trimmer or clipper,
or wash the trimmer head.
2. Do not use abrasive,alcohol,gasoline or acetone etc. liquid to wash the
product.
3. You should clean the product immediately after using once.
4. For best using and clip effect,please add some lubricating oil every three
monthes.
Disjoin the comb sawtooth to outside,then add the oil into comb sawtooth.
After, join the comb sawtooth (Fig 22).
NOSE TRIMMER INSTRUCTIONS
Nose Trimmer Instruction
Turn off the shaver power, remove the shaver head, insert the flange of the
nose trimmer into the slot of the top shaver.Then press down the nose trimmer
head parts to installed in the shaver body.(hear the sound like "kaca") (Fig
23).
Trim Nose Hair
1. Make sure your nose is clean.
2. Open the switch, put the nose trimmer towards your inside nose,turn the
nose trimmer to clip your long nose hair (Fig 24).
Do not exceed 0.5cm for nose trimmer length inside your nose.
To reduce itch, you should put one side of the nose trimmer tip close your
skin.
- 12 -