Sears Craftsman 320.10871 Manual De Usario página 21

USING THE LASER TRAC _ LASER LIGHT FEATLIRE (Fig. 9)
Z_ WARNING:
LASER LIGHT. LASER RADIATION, Avoid Direct Eye Exposure,
DO NOT stare into beam. Only turn laser beam on when the saw is on the workpiece.
Class ilia laser_
NOTE: Your circular saw has a built-in laser light. To activate laser light switch,
saw must be plugged into power source.
2r
4
5
6
DO NOT turn the laser beam on until the saw
is on the workpiece
Mark the line of cut on the workpiece
Adjust the cutting angle and cutting depth
as needed
Plug in the saw and push the laser switch
forward to turn on the laser
Align laser beam with line-of-cut (see Fig 9)
Squeeze the trigger switch and slowly push
the saw forward using both hands Keep the
red laser beam on the line-of-cut
Always shut off the laser light when you are
finished cutting
Fig. 9
]
e_nh CAUTION:
The laser enhancing safety glasses that were included will
ance the laser light in bright light conditions. DO NOT wear these glasses if they
interfere with the safe operation of this saw,
LED WORKLIGHT
Your circular saw has a built-in worklight for better visibility when cutting This light is always
"ON" when saw is plugged into power source
21