Publicidad
Idiomas disponibles
Idiomas disponibles
PERSONAL
SAFETY
cont.
5. AVOID accidental starting. Re sure switch is in "OFF" position before
plugging in DO NOT carry tools with your finger on the switch. Carrying tools
with your finger on the switch or plugging in tools that have the switch in the
"ON" position invites accidents
6. REMOVE adjusting keys or wrenches
before turning the tool "ON".
Awrench
that is left attached to a rotating part of the tool may result in personal injury,
7 Do not overreach.
Keep proper footing
and balance
at all times.
Proper
footing and balance enables better control of the toot in unexpected
situations.
8. ALWAYS SECURE YOUR WORK. Use clamps or a vise to hold work when
practical
It is safer than using your hand and frees both hands to operate tool.
9 USE SAFETY EQUIPMENT, Always wear eye protection
Dust mask, non-skid
safety shoes, hard hat, or hearing protection must be used for appropriate
condilions.
10o DO NOT USE ON A LADDER or unstable
support.
Stable footing on a solid
surface enables better control of the tool in unexpected
situations,
TOOL
USE AND
CARE SAFETY
_, WARNING
: BE SURE to read and understand
all instructions
before
operating
this saw. Failure to follow all instructions
listed below may result in
electric
shock, fire and/or serious
personal
injury.
1, ALWAYS use clamps or other practical
ways to secure and support
the
workpiece
to a stable platform. Holding the work by hand or against your body
is unstable and may lead to loss of control
2. DO NOT force the tool. Use the correct tool and blade for your application,
The correct tool and blade will do the job better and safer at the rate for which it is
designed,
3 DO NOT use the tool if switch does not turn it "On" or "Off",
Any tool that
cannot be controlled with the switch is dangerous
and must be repaired.
4 DISCONNECT
the plug from the power source before making any adjustments,
changing accessories
or storing
the tool, Such preventive safety measures
reduce the risk of starting the tool accidentally.
5. NEVER leave the tool running.
ALWAYS turn it off. DO NOT leave the tool until
it comes to a complete stop.
6. STORE idle tools out of the reach of children
and other untrained
persons,
Tools are dangerous in the hands of untrained users.
7o MAINTAIN tools with care. Keep cutting tools sharp and clean. Properly
maintained tools with sharp cutting edges are less likely to bind and are easier to
control.
8 CHECK for misalignment
or binding
of moving
parts, breakage
of parts, and
any other condition that may affect the tool's operation
If damaged,
have the tool
serviced before using. Many accidents are caused by poorly maintained tools,
9. USE ONLY accessories
that are recommended
for this tool, Accessories
that
may be suitable for one tool may become hazardous when used on another tool.
6
Publicidad
