CAUTION: Beforeperformingany
serviceor adjustments:
•
Releasecontrolbar.
o
Makesure the blade and all moving
pads havecompletelystopped.
,
Disconnectsparkplug wirefrom
sparkplug and placewhere it cannot
come in contactwith plug.
LAWN MOWER
TO ADJUST CUTTINGHEIGHT
See "TOADJUSTCUFFINGHEIGI4T"in
the Operationsectionof this manual.
REAR DEFLECTOR
The rear deflector,attachedbetweenthe
rear wheelsofyour lawn mower,is
providedto minimizethe possibilitythat
objectswill be thrownout the rearof the
lawn mowerinto the operator'smowing
position.
If the rear deflectorbecomesdamaged,it
should be replaced.
TO REMOVE/REPLACE DRIVE BELT
• Remove
drive cover.
Remove
belt by
pushing
down on gear case pulley
and
rol[ing belt off it,
, Turn lawn mower on its side with
carburetor
and fuel cap up.
• Remove
blade,
° Remove
debris shield
• RemoVe
belt from engine
pulley on
crankshaft.
° Install
new belt by reversing
above
steps.
• Always
use factory
approved
belt to
assure
fit and long life..
Drive
cover
Belt
Push
down
TO ADJUST
HANDLE
Your lawn mower handle
can be raised
or
lowered
for your mowing
comfort.
Four
(4) positions
are available:
high, medium
high, medium
low and low.. Handles
are
shipped
mounted
in the medium
low
position.
• To change
from medium
low to medium
high position,
the upper and lower
handle sections
will have to be turned
over
', Remove
the cable clips.
. Remove
the controls
and operator
presence
control
bar from the upper
handle.
Remove
hairpin
cotters.
,, Disconnect
the lower handle from the
handle brackets.
,, Turn the handle
over and reassemble
the hairpin cotters
that have been
removed..
o Route cable(s)
below crossbar
of lower
handle
and reassemble
the controls
and
the operator
presence
control bar to the
upper handler
CAUTION:
The operator
presence
control
bar must pivot freely to permit
blade brake engagement
when control
bar
is released.,
Do not over tighten
the
fasteners
holding the controls
to the upper
handle.
• To change
from medium
low to high
position
only the upper handle section
will have to be turned
over.
• To change
from medium
low to low
position,
only the lower handle
section
will have to be turned
over
Medium Low
Medium High
),
Shipping Position
Low
High
Squeeze to
remove
Lower Handle
14
Hairpin Clip
Handle
Bracket