Getting Started - Dyson AM10 Instrucciones De Seguridad

Getting started

For the best performance place humidifier on the floor
in the corner of the room, facing into the center. It should
be at least 3.2ft from any wall. To avoid a cooling effect
while humidifying, the unit should be at least 3.2ft from
any people. Consider placing near to air conditioning or
heating devices to circulate air effectively.
1 2
Unscrew the cap and fill the tank to the Place the tank on top of the base.
top. Replace the cap and screw until Ensure the base is on a level surface,
hand tight. Carry by the handle. otherwise the machine will not operate.
8
3 4
Place the loop amplifier on top of the Plug into the socket and base. A small
tank. Push down until you hear a click. blue LED on the back of the appliance
Remote control docks magnetically. lights up to confirm that the machine
Attach the remote control to the top has power.
of the machine with the buttons
facing down.
5 6
Switch 'ON'. The water treatment After 3 minutes the machine will start
procedure automatically starts. to humidify. The display will show the
Water passes over a UV-C emitter to target humidity setting.
ensure that it is 99.9% bacteria-free
before misting commences. This takes
approximately 3 minutes. (During this
time humidity targets can be set and
fan mode can be switched ON'.)
9