Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
-
The charge begins.
mode and
-
disappears when the unit is fully charged.
3) CHANGING THE BATTERY PACK
The battery pack is pre-installed in the unit. If you need to replace
the battery pack :
1.
Unscrew the battery pack door (E). If necessary, remove the belt
clip (C5) or the microphone support (C4) to reach the screw.
2.
Disconnect and remove the old battery pack.
3.
Connect the new battery pack.
4.
Screw then the battery pack door (E).
Note: The battery pack is provided uncharged, so you must
charge the battery pack before using it with the transceiver.
4) LOW BATTERY FEATURES
When the battery is uncharged the RX/TX LED (16) blinks yellow.
A continuous beep sounds in TX mode.
H) TECHNICAL CHARACTERISTICS
1)
GENERAL
- Channels
- Modulation modes
- Frequency ranges
- Weather channels
- Antenna impedance
- Power supply
- Dimensions
- Weight without antenna
- Accessories supplied
2)
TRANSMISSION
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the
adjacent channel
appears on the display to indicate charging
indicates the charging level.
: 40
: AM
: from 26.965 MHz to 27.405 MHz
: 162,400 MHz to 162,550 MHz
: 50 ohms
: 13.8 V (Mobile configuration)
inches : 5.98 (H) x 2.62 (W) x 1.46 (D)
mm : 152 (H) x 66.5 (W) x 37 (D)
: 0.67 lb with battery pack
: See page 2
: +/- 200 Hz
: 4 W
: inferior to 4 nW (- 54 dBm)
: 300 Hz to 3 KHz
: inferior to 20 µW
21
blinks on the display.
7.4 V (Handheld configuration)
305 g with battery pack,
Publicidad
Tabla de contenido
