Flex L 8-11 115 Instrucciones De Funcionamiento Originales página 24

L 8-11 115 / L 8-11 125 / LE 9-11 125 / L 10-11 125 / L 14-11 125 / LE 14-11 125
Press and hold down the spindle lock (1.).

Using the stop key, loosen the clamping

nut on the spindle in an anti-clockwise
direction and remove (2.).
Insert the grinding wheel in the correct

position.
Screw the clamping nut with flange face

up, onto the spindle.
Press and hold down the spindle lock.

Tighten the clamping nut with the pin

wrench or stop key.
Carry out a test run to check that the tool

is clamped in the centre.
Test run
Insert the mains plug into the socket.

Switch on the angle grinder with the

switch (without engaging it) and run the
angle grinder for approx. 30 seconds.
Check for imbalances and vibrations.
Switch off the angle grinder.

24
Switching on and off
Brief operation without engaged switch
rocker
Push the switch rocker forwards and

hold in position.
To switch off the power tool, release

the switch rocker.
Continuous operation with engaged
switch rocker
Push the switch rocker forwards (1.) and

engage by pressing the front end (2.).
To switch off the power tool, release the

switch rocker by pressing the rear end.
NOTE
Following a power failure, the switched on
power tool does not restart.