Connecting A Headset; Plugging In A Headset; Removing The Headset - Vokkero GUARDIAN EUROPE Standard Guia Del Usuario

VOKKERO GUARDIAN EUROPE Standard & Plus - User Guide V2.0.0

3.3. Connecting a headset

Several types of headsets from the VOKKERO range can be connected to VOKKERO Guardian. The headset is automati-cally
detected by the terminal when the headset is plugged in.
3.3.1.
EN
3.3.2.
To remove the headset
• Firstly, pull on the ring of the headset to release the connector switch.
• Then remove the headset connector
Use the "Micro" icon on the terminal screen to make sure that the headset is properly connected. After disconnection of a head-
set, it is necessary to wait a few moments for the micro icon to be crossed out before reconnecting a headset.

Plugging in a headset

Plug the headset into the slot at the top of
the product, beside the LCD.
Line up the 2 red marks of the product and
the connector
Note:
Do not force the headset; it should connect
easily; if this is not the case, check the head-
set to make sure it isn't dam-aged.

Removing the headset

Do not attempt to remove the head-
set by pulling the cable.
No accessory connected
Attention
Accessory connected
Attention
Do not turn the connector
46 / 122