Start Up - Truper TAPI-8 Manual De Instrucciones

Depth Scale Lock
When drilling orifices with the same depth, a depth scale lock is used.
TAPI-13
TAPI-15
Depth Limit
TAPI-17
Lock
• Unscrew the lock and turn the
graduated collar until reaching the
required depth indicated in the pointer.
• Adjust the lock back.
Table Inclination
Adjusting
Screw
• Loosen the adjusting screws and remove the setscrew
(TAPI-13, TAPI-15 and TAPI-17)
• Adjust the required angle using the scale.
• Firmly adjust back the screws.
Drill Speed Adjustment
CAUTION
• Disconnect the drill from the power
supply.
• Open the guard bands.
• Loosen the tension fastening knob(s) and push the
motor into the chuck direction. The TAPI-13, TAPI-15 and
TAPI-17 drills also have a tension lever to loosen the
bands.
• Adjust the bands with the pulleys matching the required
speed (see the checkbox "Speed in Revolutions per
minute" in page 7 or in the next Reference Table found
underneath the bands guard.)
• Close the bands guard.
8
ENGLISH
Depth
Limit
Screw
• Adjust the depth limit screw to the
drilling depth required.
The axis will only go down to that
depth.
Chucks
Threaded
Nail
(TAPI-13,
TAPI-15
and
TAPI-17)
• To attach a bit, hold the upper part
of the quick action chuck and turn

Start Up

ON
OFF
TAPI-8
• ON
• OFF
• Remove to lock
TAPI-13
TAPI-15
TAPI-17
the lower part.
Adjustable
Bands
Pulleys
TAPI-8
ON
TAPI-13
OFF
TAPI-15
TAPI-17
Security key
TAPI-8
• To attach a bit open the
chuck with the specially
designed key and close the
chuck with the special key.
Reference Table to
adjust speeds in RPM
Band
Tension
Lever
Bands
Guard
Tension
Securing
Knob