ColdKit Matrix Manual Del Usuario página 5

1.
Prepare the assembly site:
1.1. Ensure that the floor is at the correct height around the full perimeter of the cold room.
1.2. Make sure that the corners where the floor panels will be installed form an angle of 90º.
2(A). MATRIX WITHOUT FLOOR
They differ slightly from the cold rooms with floor in the assembling of the floor rack
dimension* so that they can support the vertical panels
*Dimensions depending on the thickness of the cold rooms walls.
2.1. Placement of the floor racks with an angle of 90º.
2.2. Placement of the floor racks:
2.2.1. Distribute the floor racks (
2.2.2. The space for the door(s) should be free.
Now you have the cold rooms limits well defined.
Mark on the surface the place of the holes.
2.2.3.
Use a drill to make a 55 mm hole in depth with a M10 drill.
2.2.4.
Fix all the oor racks using wedges and the given screws.
2.2.5.
IMPORTANT NOTE:
The floor rack should be positioned with
side holes facing to the interior of the
coldroom.
and are fixed to the floor.
(Piece D)
according to the selected layout of the cold room.
Part C1)
55mm
. These pieces have a different
(Piece C1)
Lateral holes on top
EN