Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
AC Power
This product has a auto-ranging power supply that can work with an input voltage range of 100–240 VAC, 50/60 Hz.
AC Plug
Connection
AC Live
AC Neutral
AC Ground
Replacing The Fuse
1.
Disconnect this product from power.
2.
Using a Phillips #2 head screwdriver, unscrew the fuse holder cap from the housing.
3.
Remove blown fuse and replace with a good fuse of the same type and rating.
4.
Screw the fuse holder cap back in place and reconnect power.
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
DMX Linking
The Ovation H-265WW will work with a DMX controller using a 5-pin DMX serial or a hard wire connection. A DMX Primer
is available from
www.chauvetprofessional.com.
DMX Connection
The Ovation H-265WW uses a 5-pin DMX or a hard wire data connection for its DMX personalities: 1, 2, 3 or 6. See the
User Manual for information about connecting and configuring the product for DMX operation.
Master/Slave Connection
The Ovation H-265WW uses the DMX data connection for its Master/Slave mode. See the User Manual for information
about how to connect and configure the product for master/slave operation.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. The Ovation H-265WW supports RDM protocol that allows feedback to monitor temperature
and changes to DMX Address, DMX Personality, Dimmer Mode, and LED Frequency menu options. Download the
User Manual from
www.chauvetprofessional.com
Wireless Operation
In optimal conditions, the Ovation H-265WW can operate up to 300 m (900 ft) away from the W-DMX transmitter. The W-
DMX receiver in the Ovation H-265WW must be paired with the W-DMX transmitter for wireless operation.
Initial Setup
1.
Turn the W-DMX transmitter on.
2.
Connect the W-DMX transmitter to a DMX controller.
3.
Place the Ovation H-265WW within 300 m from the W-DMX transmitter.
4.
Disconnect any DMX cable from the Ovation H-265WW.
5.
Turn the Ovation H-265WW on.
Configuration
1.
From the Ovation H-265WW control panel, go to DMX Address.
2.
Select the start address, as with any other DMX compatible product.
3.
Go to Wireless Setting > Receive On/Off.
4.
Select On. (The Signal Strength Indicator will show a ? in front of the bars)
5.
Press the reset button on the W-DMX transmitter. (The Signal Strength Indicator on the Ovation H-265WW will
show a ϟ in front of the bars for 3 seconds while a connection is established.
Ovation H-265WW QRG Rev. 4
QUICK REFERENCE GUIDE
Wire (U.S.)
Black
White
Green/Yellow
for more details.
Wire (Europe)
Brown
Blue
Green/Yellow
EN
Screw Color
Yellow/Brass
Silver
Green
2
Publicidad
Tabla de contenido
