Trigger Lock Setup; Switching; Hal Setup; Lal Setup - Ega Master EGA TRONIK 51262 Manual De Instrucciones

TRIGGER LOCK SETUP

This feature is to set trigger lock or unlock.
To lock or unlock the trigger, follow the below procedures:
1. Press SET to select trigger lock setting, the
2. Press or
When the trigger is locked, the Thermometer is on for continues measurement, there is no need
to pull the trigger.
When the trigger is unlocked, user needs to pull the trigger for measurement. When you release
the trigger, the Thermometer will keep hold the measurement result automatically.
SWITCHING ºC/ºF
This feature is to select ºC or ºF.
1. Press SET to choose ºC/ºF selection mode.
2. Press or

HAL SETUP

This feature is to set up the high limit. When carrying out measuring, the Thermometer beeps
continuous if the temperature is over this limit.
1. Press YELLOW button to toggle to HAL mode.
2. Press to increase the value by 0.1 or press and hold
maximum value is reached. The thermometer stops and beeps.
3. Press to increase the value by 0.1 or press and hold
minimum value is reached or ot lower than LAL value. The thermometer stops and beeps.
4. Press SET to confirm this setting, the LCD displays HIGH.
5. This feature is not valid when carrying out measurement with TC-K type thermocouple.
6. HAL value cannot set below the LAL value.

LAL SETUP

This feature is to set up the low limit. When carrying out measuring, the Thermometer beeps
continuous if the temperature is below this limit.
1. Press YELLOW button to toggle to LAL mode.
2. Press to increase the value by 0.1 or press and hold
maximum value is reached or higher than HAL value. The thermometer stops and beeps.
3. Press to decrease the value by 0.1 or press and hold
minimum value is reached. The thermometer stops and beeps.
4. Press SET to confirm this setting, the LCD displays.
5. This feature is not valid when carrying out measurement with TC-K type thermocouple LOW.
6. HAL value cannot set higher than the LAL value.
30
to select ON or OFF.
to select ºC or ºF.
is blinking.
to access quick setting until the
to access quick setting until the
to access quick setting until the
to access quick setting until the