Makita PW5001C Manual De Instrucciones página 7

Installing or removing abrasive disc (optional
accessory)
1
2
3
006100
Remove all dirt or foreign matter from the pad. Screw the
pad onto the spindle with pressing the shaft lock. Attach
the disc to the pad so carefully that the edges of disc and
pad overlap each other without protruding.
To remove the abrasive disc, pull off its edge from the
pad.
006101
Hose connector assembly
3
4
2
004736
Use the hose connector assembly to connect to water
source. It consists of the following parts.
Part name
Hose Connecter
Connecter
Hose
006438
Assemble the above parts hand tight as follows.
1. Attach the hose connector to the outlet of water
cock.
2. Tighten the connector firmly to the hose. Insert the
connector to the hose connector as far as it will go.
3. Tighten the hose connector to the end of the hose.
4. Fit the hose connector to the port on the tool.
1. Abrasive disc
2. Pad
3. Spindle
1. Water cock
1
2
2. Hose connector
3. Connector
4. Hose
Description
1/2" pipe thread
1/2"mail pipe thread
5/8"in inner diameter x 25" in length
OPERATION
Polishing operation
006102
006103
WARNING:
To reduce the risk of electric shock, check the tool's
•
water supply system to ensure there is no damage
to the seals ("O" rings) or hoses. A damaged water
supply system may result in abnormal water flow to
the tool which could be dangerous.
CAUTION:
Always wear safety goggles or a face shield during
•
operation.
Never switch on the tool when it is in contact with
•
the workpiece, it may cause an injury to operator.
Never run the tool without the abrasive disc. You
•
may seriously damage the pad.
Be sure to feed water to the abrasive disc during
•
operation. Failure to do so may cause breakage to
the tool.
The maximum permitted pressure of water supply
•
is 7 bar.
Make sure that the cock is closed. Connect the hose to
the tool. Make sure that water comes out when the water
lever is opened.
Hold the tool firmly. Turn the tool on and then apply the
abrasive disc to the workpiece.
Apply slight pressure only. Excessive pressure will result
in poor performance and premature wear to abrasive
disc.
7