Gabarron ADL 2012 Instrucciones De Instalacion Y Uso página 7

Acumuladores dinámicos
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1.
WARNING
• Please read these instructions before installing or using this appliance for the first time. The warranty of
the storage heater will not cover any damage caused by non-observance of any of these instructions.
• This Guide must be kept and given to any new owner for future references.
• Nothing may be placed in the 30 cm in front of the heater at any time. This is to avoid items
coming into contact with the grille and the head air which leaves, it. Blocking some or all of
this area could represent a fire hazard. Never use this heater to dry clothes.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision
or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
Children must not play with the appliance. Cleaning and user maintenance must not be made by children
without supervision.
• Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it
has been placed or installed in its intended normal operating position and they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the
appliance or perform user maintenance.
• Children of less than 3 years should be kept away unless continuously supervised. Please check that the
voltage in the rating label fits the power supply.
• Should the heater be moved and reinstalled it is essential that the work is carried out by a fully qualified
engineer. Before carrying out any work inside the appliance, the heater must be disconnected from the
electricity supply.
• If during any installation the thermal insulation shows any sign of damage, it is necessary for the faulty
part to be removed and replaced by an identical part.
• The use of storage heaters is forbidden in any area where there is a presence of gases, explosives or
inflammable objects.
• The air inlet and outlet grills are provided to ensure the most efficient operation of the appliance. They
also protect the heater from overheating; therefore, it is essential that at no time are they covered.
• Surfaces of this appliance could be hot. Children should be supervised to ensure they do not play with
the heater.
• This heater should be switched off at the isolating switch before any repair work is carried out. This
action should also be taken during the times of the year when heat is not required.
• The installation of the heaters must be carried out in such a way that each pole can be disconnected from
the supply having a contact separation of at least 3 mm.
• The storage heater should not be installed just below an electrical socket.
• Ensure that both wall supply switches next to the heater are turned on. During the summer when no
heat is required, both wall switches can be turned off. Remember to turn both back when the heat is
required again.
• The appliance must be installed in such a way that it is impossible for anyone using a bath or shower, to
touch the controls. Never touch the heater with wet hands.
• The nominal charging time of this storage heater is indicated on its rating plate and must be controlled
by means of a programmer. Never open a charged heater.
• The installation must be carried out in accordance with the current electrical regulations. Check the
voltage in the rating label is the same than supply.
• This appliance must be earthed.
• After installation a survey of the first charging cycle should be carried out to ensure that the main input
thermostat switches off. Ventilate the room during this first cycle.
• The fan may run at any time. This will happen automatically to maintain the temperature that you have
programmed into the control system.
• To maintain stability, it is essential that the heater is placed on a level surface and care should be taken
to avoid irregular surfaces, such as may result from carpets or tiled surrounds partially protruding under
the heater.
7

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido