Using The Signal Interface Switcher - Sony VPH-G70Q Manual De Instalación

Using the Signal Interface Switcher

When the switcher is connected to the projector using the SIC-M or CCQ-BRS connecting cable
SIC-M or CCQ-BRS
connecting cable
to
REMOTE 1
OUT
PC-1271/1271M
Switcher
Video
equipment
28
(EN) Connections
When you connect the PC-1271/1271M Signal Interface Switcher (not
supplied) to the IFB-40 Signal Interface Board (installed on the projector by
default), you can connect easily various input sources.
You can select up to 16 inputs by pressing the SWITCHER/INDEX keys on
the remote control or by setting SWITCHER in the INPUT SELECT menu.
IFB-40 Signal Interface Board
IN
INPUT A S VIDEO TRIGGER
R
R-Y Y IN
P R
G
C IN
Y
B
B-Y IN
P
B
ABL LINK
SYNC
OUT
HD
IN
VIDEO
VD
OUT
IN
OUT
VIDEO IN
to video output
to RGB output
Computer
Choose the appropriate cable from the following table.
1 m 2 m
— CCQ-2BRS CCQ-5BRS CCQ-10BRS —
SIC-M-1 —
Notes
• Insert the female and male plugs of the SIC-M or CCQ-BRS cable correctly.
• You can extend the SIC-M or CCQ-BRS cable up to 50 m.
• The video signal input to the signal interface board installed to the INPUT B
section should not exceed 70 MHz. When projecting the video signal which
exceeds 70 MHz, connect the signal source to the INPUT A connectors using
the 5BNC cables.
Setting up
• Set INPUT-A in the SET SETTING menu to RGB.
For details, see "The SET SETTING Menu" on page 51 (EN).
• Select VIDEO or S VIDEO by pressing the INPUT SELECT keys on the
remote control or by setting VIDEO in the INPUT SELECT menu.
For details, see "The INPUT SELECT Menu" on page 45 (EN).
• Set the SINGLE/SECOND/OTHER select switch on the switcher to
SINGLE.
Rear
REMOTE
RS-422A
CONTROL S
IN
PLUG IN INDEX
POWER
OUT
S VIDEO IN
to S Video output
Video
equipment
5 m 10 m
SIC-M-5 —
MAIN POWER
OFF ON
AC IN
100~120V 15A 250V
200V~240V T6.3A 250V
AC power cord
AC IN
(supplied)
to a wall outlet
15 m 25 m 50 m
CCQ-25BRS CCQ-50BRS
SIC-M-15 SIC-M-25 SIC-M-50