Sony VPH-G70Q Manual De Instalación página 34

Connecting Multiple Projectors
34
(EN) Connections
Notes
• Insert the female and male plugs of the SIC-M or CCQ-BRS cable correctly.
• You can extend the SIC-M or CCQ-BRS cable between the switcher and the
first projector up to 50 m.
• The video signal input to the signal interface board installed to the INPUT B
section should not exceed 70 MHz. When projecting the video signal which
exceeds 70 MHz, connect the signal source to the INPUT A connectors using
the 5BNC cables.
Setting up
• Set INPUT-A to RGB and 5BNC MODE to ON in the SET SETTING
menu.
For details, see "The SET SETTING Menu" on page 51 (EN).
• Set the SINGLE/SECOND/OTHER select switch on the switcher to
SINGLE.
• To control the projectors using the index number, set the sequential
number from 01 to 08 on each projector using the INDEX NO. switches
on the rear panel.
• Set the MODE selector on the IFB-40 installed to the first projector to
the appropriate position according to the length of the SIC-M or CCQ-
BRS cable between the first and second projectors.
For details, see "Location and Function of Connectors" on page 23 (EN).