Sony VPH-D50HTU Manual De Instalación página 97

Preset data at the factory
Memory architecture
Standard registration data and the input memory
If the adjusted registration data is saved as the standard data after installing
the projector, the registration data for all of the input memories will be
changed to reflect the new data in that installation condition. Therefore,
you can easily adjust the registration for each input signal.
For the procedure of how to save the standard data, see page 88 (GB).
The projector presets seven types of basic data in memory numbers 00 to
06 of the factory data and service data blocks.
Memory number
Horizontal
frequency (fH)
00 15.7 kHz
01 24.8 kHz
02 31.5 kHz
03 48.3 kHz
04 64.0 kHz
05 31.5 kHz
06 33.8 kHz
The following adjustment data will be saved in three memory blocks.
Memory Adjustment data
Input memory Picture control (CONTRAST,
BRIGHT, COLOR, HUE,
SHARP)
SIZE/SHIFT
Blanking
Color temperature
Clamp position
V SHIFT
Registration
Color temperature White balance
memory (BIAS/GAIN data for
each color temperature
of each screen)
Setting memory Baud rate, CRT timer,
STATUS ON/OFF, language,
index, video memory, etc.
Vertical Type of the
frequency (fV) input signal
60 Hz Video (NTSC
56 Hz RGB
60 Hz RGB
60 Hz RGB
60 Hz RGB
60 Hz IDTV (NTSC
60 Hz HDTV (Y/P
Number of memories
Memory numbers 00–49
(50 at maximum)
Four color temperature
settings (9300K/6500K/
5400K/3200K)
One for each projector
Adjustments
)
3.58
)
3.58
/P )
B R
97
(GB)