Wired Controller Operation - mspa ELITE Serie El Manual Del Propietario

WIRED CONTROLLER OPERATION

Heater Button
Bubble Button
- Adjust the bubble level by pressing
Up Button
Toggle Button
Temperature display: press RESET on PRCD, read the current temperature on the screen.
Jet Button: To activate the water jet massage function.
NOTE: The Bubble button can only be adjusted between L1 (300W) and L2 (500W) while the Jet
JET
function is on. JET function will shut down automatically after one-hour continuous operation.
Heater Button:
The filter will automatically be running for 15 seconds to test the working condition once the HEATER
HEATER
function is started. If there is no abnormality, the heater will keep working until the water temperature
reaches the set value. When the water temp goes below the set temp, the heater will restart to heat
the water automatically. The HEATER button displaying red means that the heating system is
activated. The HEATER button displaying green means that the system is at rest and keeping the
water at the set temp.
Filter Button:
FILTER
green when activated.
NOTE: Filtration cannot be turned off when Heating is activated. When the Heating function is turned
off, filtration will be stopped after 30 seconds. Filtration function can then be activated separately.
NOTE: The auto-filtration system is automatically activated every 4 hours.
Bubble Button:
BUBBLE
power is at level 2 (500W). Press the BUBBLE button again, switching to level 3 (720W). Press again
Press HEATER button to start or stop heating.
Can adjust among 3 levels of bubbling power. The default bubbling massage
JET
17
Jet Button
Filter Button
Timer Button
Down Button
Ozonator Button