Victron energy MPPT 150/35 Manual Del Usuario página 10

Ocultar thumbs Ver también para MPPT 150/35:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 67
On all models with software version V 1.12 or higher a binary
LED code helps determining the position of the rotary switch.
After changing the position of the rotary switch, the LEDs will
blink during 4 seconds as follows:
Switch
position
0
1
2
3
4
5
6
7
Thereafter, normal indication resumes, as described below.
Remark: the blink function is enabled only when PV power is
present on the input of the controller.
3.6 LEDs
LED indication:
 permanent on
 blinking
 off
Regular operation
Bulk (*1)
Absorption (*2)
Automatic equalisation (*2)
Float (*2)
Note (*1): The bulk LED will blink briefly every 3 seconds when the system is powered but
there is insufficient power to start charging.
Note (*2): The LED(s) might blink every 4 seconds indicating that the charger is receiving
data from another device, this can be:
A GX Device (eg Color Control with a Multi in ESS mode)
A VE.Smart network link via Bluetooth (with other MPPT chargers and / or a
BMV or Smart Battery Sense)
Fault situations
Charger temperature too high
Charger over-current
Charger over-voltage
Internal error (*3)
Note (*3): E.g. calibration and/or settings data lost, current sensor issue
8
LED
LED
Bulk
Abs
1
1
0
0
0
1
0
1
1
0
1
0
1
1
1
1
LEDs
LEDs
LED
Float
frequency
1
1
0
1
0
1
0
1
Bulk
Absorption
Bulk
Absorption
.
Blink
Fast
Slow
Slow
Slow
Slow
Slow
Slow
Slow
Float
Float

Publicidad

Tabla de contenido
loading

Tabla de contenido