Package Contents - MELICONI AD-PHOTO Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 8
The AD PHOTO amplifi ed indoor aerial receives digital terrestrial TV, DAB and FM radio signals and VHF and
UHF traditional analogue TV signals.
A. Locating the aerial
The aerial should not be positioned on top of the television or near metal objects, electric appliances or
reinforced concrete walls as they would limit operation.
B. Installation
- Make sure the digital terrestrial decoder is turned on
- Connect the cable of the Meliconi aerial to the aerial socket at the back of the digital terrestrial decoder
(1).
- The decoder may not be designed to power an aerial (see decoder instructions). In this case, use the AC/
DC adaptor included in the pack. Plug the cable into the aerial power input socket, then connect the adaptor
to an electrical socket (2)
- Mount the aerial as required, on a table-top base (included in the pack) either horizontally (fi gure 3a) or
vertically (fi gure 3b) or on a wall.
Change the position and orientation (horizontal/vertical) of the aerial until reception is optimum.
To install the aerial on a wall, proceed as follows: a. Drive the two nails provided in the pack into the wall,
80 mm (3.149") apart. b. Fit the plastic bracket included in the pack into the two holes at the back of the aerial
(4). After insertion, press to block in place (5). c. Insert the two nails in the wall into the two holes in the bracket
(6).
C. Troubleshooting
• If the aerial does not work, fi rstly make sure it is powered correctly.
• Powering via the aerial cable could be momentarily disabled on your decoder. In this case, follow the
instructions with your decoder to enable the function or connect the aerial to the power adaptor provided.
TWO-YEAR WARRANTY - Tampering or improper use of the product invalidates the warranty
CHARACTERISTICS AND TECHNICAL SPECIFICATION
Amplifi ed indoor digital aerial
Reception of digital terrestrial TV (DVB-T) signals, DAB radio signals and VHF, UHF and FM signals.
Reception range: VHF 88 ~ 240 MHz UHF 470 ~ 862 MHz
GSM and wireless device interference suppression fi lter
Extremely low noise factor (< 3.5 dB)
Amplifi cation: 20 dB
5V DC provided by the DVB-T decoder through the aerial cable or 6V DC from the adaptor included in the
pack.

PACKAGE CONTENTS

• Table top mount
• Wall bracket
• Nails for wall
• AC/DC adaptor
• Coaxial cable: IEC male to IEC male right angle (1830 mm)
• Cable tie
• IEC female to F male adaptor
This symbol appearing on a product or its packaging indicates that the product must not be considered as normal
household waste, but must be taken to a special waste collection centre for recycling electric and electronic appliances.
Disposing of this product appropriately helps avoid any potentially negative consequences which could arise from its
incorrect disposal. For more detailed information on recycling of this product, contact your local council, the local waste
disposal service or the shop where you bought the product.
Istruzioni AD PHOTO definitive.i4 4
Istruzioni AD PHOTO definitive.i4 4
"AD PHOTO" AMPLIFIED INDOOR
DIGITAL TERRESTRIAL TV AERIAL
INSTRUCTIONS
Thank you for choosing MELICONI.
GB
18-07-2007 16:40:41
18-07-2007 16:40:41

Publicidad

Tabla de contenido
loading

Tabla de contenido