TO DISPLAY TEMPERATURE IN THE CELL
To display the temperature in the cell, press either the up
or down arrow on the SELECT button (A) to index forward
or backward through the grain (function) menu until the
word TEMPERATURE is displayed.
When TEMPERATURE is displayed, press
TEST button (B). The current temperature in
cell will be displayed in both F˚ and C˚. Temper-
ature will be displayed for a few seconds then
will return to the main grain menu.
NOTE: If the tester and grain are different
temperatures, the mass of the metal tester
will quickly warm or cool the grain. Therefore, the temperature reading is
the cell temperature, not necessarily the temperature of the grain before
being put in the cell.
TO AVERAGE TEST RESULTS
1. When testing grain, the test result is dis-
played for about ten seconds. During the
period that the test moisture % and tem-
perature is displayed, press the MEMORY
button (A). The tester will acknowledge
that it has entered the reading into mem-
ory, by displaying the current average and
then the number of stored readings. Up to
20 readings can be stored into memory.
If the maximum number of readings has
been reached, the tester will not allow any
more readings to be stored.
NOTE: Averaging is stored for one grain only. When
a test for a new grain is performed, existing averag-
ing data for the previous grain is erased when the
new grain's averaging data is taken. Averaging data
is retained even if batteries are removed.
2. Press the AVG button (B) to display the average of
all results entered for the grain being tested.
3. To clear the averaging, press the AVG button. The current average will be
displayed. Then press the CLEAR button (C) and the tester will then display
0.0% ( 0 ). This indicates that the averaging has been cleared.
Operation
7