Care Instructions; Protect Against Freezing; Cleaning The Spray Arms - General Electric GLFS1224SSI Manual De Uso

• Inspect filters for obstructions after using
the dishwasher.
Close
Step 1. Remove coarse filter
by turning it.
Note: Follow the above steps in reverse order to replace filtering system.

Care instructions

• To clean the control panel use a lightly
dampened cloth then dry thoroughly.
• To clean the exterior use a good appliance
polish wax.

Protect against freezing

If your dishwasher is left in an unheated place during the winter, ask a service technician to:
1. Cut off electrical power to the dishwasher.
2. Turn off the water supply and disconnect
the water inlet hose from the water valve.
3. Drain water from the inlet hose and water
valve. (Use a pan to catch the water).

Cleaning the spray arms

It is necessary to clean the spray arms regu-
larly since hard water minerals will clog the
spray arm nozzles and bearings. To remove
the spray arm, unscrew the nut and take out
the washer on top of the spray arm. Remove
spray arm. Wash arms in soapy warm water,
and use a soft brush to clean the nozzles. Re-
place arm after rinsing it thoroughly.
34
• Unscrew the coarse filter so you can re-
move the filter system. Remove any food
particles and clean the filters under run-
ning water.
Step 2. Remove the main fil-
ter by lifting it up.
• Never use sharp objects, scouring pads or
harsh cleaners on any part of the dish-
washer.
4. Reconnect the water inlet hose to the wa-
ter valve.
5. Remove the filter in the bottom of the tub
and use a sponge to soak up water in
sump.
Step 3. Remove the fine filter
by lifting it up.