Logo Cap Installation; Tack/Glue Board For Enclosure - Hunter STK-1 Instrucciones De Instalación

Sistema del receptáculo y aspersor de césped sintético
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTallaTIoN INSTruCTIoNS for huNTEr STK-1
Prior to installing the rubberized logo cap, the riser assembly must
be pulled up above the upper snap-ring's rubberized seal. If this
procedure is not followed, the rubberized logo cap's stainless steel
screw cannot reach the riser assembly below and attachment will
be impossible.
fIGurE 13
To pull the riser assembly above the upper snap-ring's wiper seal,
first locate the lift-up socket on top of the riser assembly. Using
the T-Handle Tool or Snap-Ring Tool or Hunter Wrench, insert the
tool into the lift-up socket, turn ¼ turn (fig 14). Next, lift the riser
assembly up until the nozzles can been seen above the upper
snap-ring assembly (fig 15). Slowly release the riser assembly
downward until the riser assembly rests on top of the upper
snap-ring assembly (fig 16).

logo Cap Installation

Prior to installing the rubberized logo cap, note there is a protruding
pin on the underside of the rubberized logo cap (fig 17). This pin
is the alignment feature on the rubberized logo cap that must
be oriented and inserted into the riser assembly correctly. Proper
alignment and installation of the protruding pin allows the nozzle
direction arrows on the rubberized logo cap to be positioned over
the nozzles below. Note which hole in the top of the riser that the
pin fits into (fig 18).
fIGurE 14
fIGurE 15
When installing the Rubber Cover Kit's logo cap, it is highly
recommended to first lift up the riser assembly with the T-handle
tool and hold the riser in this raised position while installing the
logo cap. Orient and place the logo cap on the top of the riser.
Attach the rubberized logo cap using a Phillips screwdriver and
the screw provided. Tighten the stainless screw clockwise until the
screw is hand tight. Do not over-tighten.
fIGurE 16

Tack/Glue board for Enclosure

In most instances, a tack/glue board is specified to be constructed
around the perimeter if the ST173026B enclosure. The responsibility
to build the tack/glue board may or may not be the responsibility
of the irrigation contractor. The purpose of the tack/glue board is
to provide a means to securely attach the synthetic "carpet" around
the perimeter of the enclosure. Depending on Synthetic Turf Field
contractor, the carpet will be attached with tack nails or glued or both.
The most common tack/glue board construction material is Trex™ type
2"x 4" lumber. Depending on the field design and the location of the
enclosure, the tack board will be an independent perimeter board or,
attached to the field perimeter tack/glue board as shown below.
The tack/glue board rests upon the compacted field base material. The
design can be a very close-fitting frame about the enclosure's exposed
fIGurE 17
fIGurE 18
ENG
13

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Stk-2

Tabla de contenido