Installing Rotor Rubber Cover Kit; Attaching Rotor To The Stvbvfk Kit - Hunter STK-1 Instrucciones De Instalación

INSTallaTIoN INSTruCTIoNS for huNTEr STK-2
outlet fitting attached to the ICV valve. Elbow fitting should be
hand threaded clockwise until it stops then turned counter-clockwise
to align for vertical installation of the rotor. Do not install rotor at
this time.
Attaching STVBVFK Kit to the ST2008VA Swing Joint
Remove the red protective cap from the inlet side of the STVBVFK
assembly. Next, thread the assembly onto the VA swing joint by
hand clockwise until it stops. Now rotate the assembly counter-
clockwise until it is vertically aligned.

Installing rotor rubber Cover Kit

First, remove the green logo cap on the rotor. It is much easier to
align and install the rubber cover kit to the rotor before the rotor is
attachment to the STVBVFK assembly. First, note the general shape
and orientation of the large circular rubber boot that must fit over
the rotor's flange (rotor's upper surface). Also note that there are
recessed areas on the underside of the boot that must align with
the ribs on the underside of the rotor's flange. It is easiest to attach
the boot at the narrowest section first. Hold the rotor so that the
rotor's compartment is facing away from you and you can see ribs
on the underside of the rotor's flange. Find the part on the boot
where the hole in the boot is closest to the outer edge. Attach this
narrow section first while taking care to align the boot to the ribs
under the rotor's flange. Continue attaching the remaining sections.
Once complete, confirm that all ribs on the rotor are aligned with
the recessed areas on the boot.
Do not install the center logo cap from the rubber cover kit at this time.

attaching rotor to the STVbVfK Kit

Remove the red protective cap from the Acme outlet elbow
attached to the STVBVFK assembly. Next, thread the Rotor onto
the assembly by hand clockwise until it stops. Now rotate the rotor
counter-clockwise until the rotor's side compartment faces towards
the off-field side of the enclosure (see Top View installation drawing).
Lower rotor, valve and swing joint assembly into the enclosure.
ENG
19