Starting-Up And Operating The Wine Guardian; Control Settings - Wine Guardian SS018 Guía De Instalación, Operación Y Mantenimiento

Starting-up and Operating the Wine Guardian

Control Settings

Controller Functions
ON/OFF – The ON/OFF button will be used to turn the system on or off. When set to the off mode the control
will not allow any of the outputs to energize effectively locking the system out. It will not allow any outputs to
energize until the system is turned on with the ON/OFF button. It should be noted that high voltage will still
be present at the main control board when the system is set to off even though the control will not allow it to
switch to the outputs.
UP Arrow – The UP arrow will allow the user to increase settings.
DOWN Arrow – The DOWN arrow will allow the user to decrease settings.
SETTINGS – The setting button will be used to select between HEAT, COOL and AUTO MODE, as well as
entering the configuration settings. Holding the SETTINGS button for 5 seconds will enter configuration mode.
Once in configuration mode the user can adjust settings by pressing the UP or DOWN arrows. Pressing the
SETTINGS button once will advance to the next configuration settings. Holding the SETTINGS button for 5
seconds while in configuration mode will store all changes and exit configuration mode.
For cooling operation only: Cooling for 60Hz models is set at 55°F from the factory and 13°C for 50Hz models.
This can be changed by hitting the UP or DOWN arrow, but please refer to configuration settings # 2 and # 3
for limitations in comparison to the High and Low temperature alarm settings.
For units with optional humidifier controlled by SS018 WG: The RH% is factory set at 55%. This can be
changed by referring to configurations setting # 6. If no humidifier is attached, the control will read RH%, but
will not be controlling it.
Changing fan operation: The default setting from the factory is "AUTO" fan. If desired it can be changed to fan
"ON" by accessing configuration setting # 7.
46
The control has been wired and set up in the factory for testing with default
settings. It is an electronic digital thermostat for single-stage cooling. No
additional adjustments should be necessary except adjusting the cellar
temperature to your preference. If additional adjustments or changes are
necessary, please refer to the configuration settings section in this manual.