How To Use The Accessories; Important Application Instructions - Kärcher SC 2 EasyFix Guía Inicio Rápida

 Set selector switch to the required
steam volume.
 While operating the steam switch, al-
ways direct the steam gun at a separate
piece of cloth until the steam is emitted
evenly.
Note:
The heating of the steam cleaner is
turned on in regular intervals during the
operation of the appliance in order to
maintain the pressure in the boiler at a
constant level. When the heating is
turned on, the orange indicator lamp
(heater) lights up.
Refilling Water
Water needs to be filled into the boiler, if the
steam volume decreases during work and
no more steam is emitted in the end.
Note:
The safety lock cannot be opened as long
as slight pressure remains in the boiler.
Illustration
 Press the OFF switch to turn off the ap-
pliance.
 Disconnect the mains plug from the
socket.
Illustration
 Push the steam switch until steam dis-
charge stops. Now, the boiler of the ap-
pliance is unpressurized.
 Remove the safety lock from the de-
vice.
 Fill the boiler with a maximum of 1 liters
of fresh tap water.
 Screw the safety cap back onto the de-
vice.
 Insert the mains plug into a socket.
 Press the ON switch to turn on the ap-
pliance.
Both indicator lamps must illuminate.
 The orange indicator lamp goes out af-
ter approximately 8 minutes.
The steam cleaner is ready to use.
20
Turning Off the Appliance
Illustration
 Press the OFF switch to turn off the ap-
pliance.
 Disconnect the mains plug from the
socket.
Illustration
 Push the steam switch until steam dis-
charge stops. Now, the boiler of the ap-
pliance is unpressurized.
Storing the Appliance
Illustration
 Fasten the power nozzle to the detail
nozzle.
 Insert the manual nozzle and detail noz-
zle onto each extension pipe.
 Put the extension pipes into the large
accessory compartments.
 Put the round brush into the medium
acessory compartments.
 Hook the floor nozzle into the parking
position.
 Wrap the steam hose around the exten-
sion pipes and insert the steam pistol
into the floor nozzle.

How to Use the Accessories

Important application instructions

Cleaning floor surfaces
It is recommended to sweep or vacuum the
floor prior to using the steam cleaner. This
way, the floor is already cleared of dirt/
loose particles prior to the wet cleaning.
Refreshing textiles
Prior to treatment with the steam cleaner,
always check the reaction of the textiles in
an inconspicuous location: Steam at first,
then let dry and then check for colour or
shape changes.
Cleaning of Coated or Lacquered
Surfaces
When cleaning painted or plastic-coated
surfaces, as found on kitchen and living
room furniture, doors, parquet; wax, furni-
ture polish, plastic surfaces or paint can
– 10
EN