Operating Instructions - GMCW RC400 Manual De Instrucciones

7
Pour Over version
1. Ensure that the water inlet valve cap supplied with the
machine is installed on the water inlet valve to prevent
leaking.
2. Open reservoir lid.
3. Fill reservoir with tap or bottled water to the level indi-
cated on reservoir. Do not use distilled water.
4. Plug unit into a 120V/15 amps receptacle. Turn main
power switch to ON.
5. Place a cup in the drip tray of the unit to collect the wa-
ter from the priming operation.
6. The screen will display "Prime Brewer". Press BREW
button until water flows into cup.
7. Refill the reservoir to the appropriate level.
8. Allow brewer to reach brewing temperature.
The water is supplied directly to the unit and
the water fill level marking is not used.
Operation is not affected by the water being
below the fill line.

Operating Instructions

WARNING Brew probes are sharp. To prevent injury, do not place fingers inside the brew chamber. To prevent
accidental overflow, press "BREW" to stop.
Step 1 – Lift brew chamber lid
ENGLISH
Note: Auto-Fill ONLY:
Fill Level
Step 2 – Insert RealCup™ capsule
Auto-Fill version
1. Plumb water to the fill valve located on the back of
the brewer. A ¼" female flare x ¼" tube adapter as
well as a ¼" flare x hose adapter provided with the
brewer. Do not use reverse osmosis water.
2. Open water service valve.
3. Plug unit into a 120V/15 amp receptacle. Turn
main power switch to ON.
4. Reservoir will automatically fill.
5. Place a cup in the drip tray of the unit to collect the
water from the purging operation.
6. The screen will display "Prime Brewer". Press
BREW button until water flows into cup.
7. Allow brewer to reach brewing temperature.
Step 3 – Close brew chamber
7