Product Addressing; Signal Output; Physical Fader Assignment; Joystick Assignment - Chauvet DJ Obey 70 Manual De Usuario

Product
Addressing

Signal Output

Physical Fader
Assignment
Joystick
Assignment
Page 12 of 72
The Obey™ 70 can control up to 12 separate fixtures. Each fixture must be set to
predetermined DMX addresses. Please see the chart below for the DMX starting
addresses of each of the 12 fixtures.
DIP
Product Address
switch
1 1 1
2 33 1,6
3 65 1,7
4 97 1,6,7
In order to use this controller with multiple fixtures, you must daisy chain from the
output of the Obey™ 70, using DMX cables to link from one fixture to another.
Use this feature to combine or unify fixture control attributes for different fixtures. For
example; if you are controlling 4 moving mirrors and 4 moving yokes, the color, gobo,
and dimmer channels may not line up ideally on the physical faders. Use this
function to reassign these channels to faders 1, 2, and 3:
1. Press <PROGRAM> and <TAP SYNC/DISPLAY>. This will enter the physical fader
assignment mode.
2. Select one of the fixtures: <FIXTURE 1–12>
3. Move the <SPEED> fader to select the physical slider (control channel).
4. Move the <FADE TIME> fader to select the DMX channel.
5. Press <MIDI/ADD> to save the setting.
6. Repeat steps 3–5 until all of the faders have been assigned for the fixture.
7. Press <PROGRAM> and <TAP SYNC/DISPLAY> two times to exit physical fader
assignment mode.
Reset the fader assignment back to the original, factory settings by performing
a soft reset. Please see the section "Resetting the System" for detailed
instructions on this procedure.
The joystick will be displayed as [SLIDERT1/SLIDERP1] for Page A, and
[SLIDERT2/SLIDERP2] for Page B.
The joystick is pre assigned to channels 15/16 (Page A) and 31/32 (Page B).
When moving channels, you must relocate the previously addressed channel
to a new location. For example: when moving channel 12 to channel 1, channel
1 must be relocated to a new channel.
The joystick is designed for moving head & scanning mirror products.
1. Press <PROGRAM> and <TAP SYNC/DISPLAY>. This will enter the physical fader
assignment mode.
2. Select one of the products: <FIXTURE 1–12> (this will be the fixture that you want to
modify the channels for).
3. Move the <SPEED> fader to select the pan control [SLIDERP1/1].
4. Move the <FADE TIME> fader to select the DMX channel to assign it to.
5. Press <MIDI/ADD> to save the setting.
6. Repeat steps 3-5 for the tilt [SLIDERT1/2].
7. Press <PROGRAM> and <TAP SYNC/DISPLAY> two times to exit physical fader
assignment mode.
When assigning the joystick to a channel (for example, channel two), you must
also relocate channel two to a new location.
DIP
Product Address
switch
5 129 1,8
6 161 1,6,8
7 193 1,7,8
8 225 1,6,7,8
DIP
Product Address
switch
9 257 1,9
10 289 1,6,9
11 321 1,7,9
12 353 1,6,7,9
Obey™ 70 User Manual Rev. 6