Publicidad
Idiomas disponibles
Idiomas disponibles
General Battery Information
Should battery acid accidentally splatter into the eyes or onto the skin,
rinse the affected area immediately with clean cold water. If there is
any further discomfort, seek prompt medical attention. If acid spills on
clothing, first dilute it with clean water, then neutralize with a solution of
ammonia/water or baking soda/water.
NEVER connect (or disconnect) battery charger clips to the battery while
the charger is turned on, as it can cause sparks. Keep all sources of ignition
(cigarettes, matches, lighters) away from the battery. The gas generated
during charging can be combustible. As a further precaution, only charge
the battery in a well ventilated area. Always shield eyes and protect skin
and clothing when working near batteries.
Batteries contain sulfuric acid and may emit explosive gases. Use extreme
caution when handling batteries. Keep batteries out of the reach of
children.
Battery Maintenance
The battery is filled with battery acid and then sealed at the factory. However, even a
"maintenance free" battery requires some maintenance to ensure its proper life cycle.
•
Spray the terminals and exposed wire with a battery terminal sealer, or coat
the terminals with a thin coat of grease or petroleum jelly, to protect against
corrosion.
•
Always keep the battery cables and terminals clean and free of corrosion.
•
Avoid tipping. Even a sealed battery will leak electrolyte when tipped.
Battery Removal
Battery posts, terminals and related accessories contain lead and lead
compounds. Wash hands after handling.
The battery is located beneath the seat frame. To remove the battery:
SERVICE AND MAINTENANCE
WARNING
WARNING
WARNING
WARNING
1.
Remove the hex washer screw securing the battery hold-down bracket to
the frame. Then flip the battery hold-down bracket up to free the battery.
See Figure 24.
Battery Hold-Down Bracket
2.
Remove the hex cap screw and sems nut securing the black negative battery
lead to the negative battery post (marked NEG). Move the cable away from
the negative battery post.
3.
Remove the hex cap screw and sems nut securing the red positive battery
lead to the positive battery post (marked POS).
4.
Carefully lift the battery out of the tractor.
5.
Install the battery by repeating the above steps in the reverse order.
Always connect the positive lead to the battery before connecting the
negative lead. This will prevent sparking or possible injury from an
electrical short caused by contacting the riding mower body with tools
being used to connect the cables.
Charging the Battery
1.
Test and, if necessary, recharge the battery after the riding mower has been
stored for a period of time.
2.
A voltmeter or load tester should read 12.6 volts (DC) or higher across the
battery terminals. See Figure 25.
Voltmeter
Reading
12 . 7
12 .4
12 .2
12 .0
3.
Charge the battery with a 12-volt battery charger at a MAXIMUM rate of 10 amps.
24
Hex Washer Screw
Figure 24
WARNING
State of
Charging
Charge
Time
100%
Full Charge
75%
90 Min .
50%
180 Min .
25%
280 Min .
Figure 25
Publicidad
