Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting the Seat
To adjust the position of the seat, rotate the seat forward and locate the two
adjustment knobs on the front of the seat pan. Refer to Figure 8.
Rotate the clamp knobs to the left and remove them, slide the seat forward or
backward and re-insert the clamp knobs into one of the four available positions on
the seat pan and into the seat, then tighten securely. Make sure the seat is locked into
position before operating the tractor. See Figure 8
Gas and Oil
Fuel Recommendations
Use automotive gasoline (unleaded or low leaded to minimize combustion chamber
deposits) with a minimum of 87 octane. Gasoline with up to 10% ethanol or 15%
MTBE (Methyl Tertiary Butyl Ether) can be used. Never use an oil/gasoline mixture
or dirty gasoline. Avoid getting dirt, dust, or water in the fuel tank. DO NOT use E85
gasoline.
•
Refuel in a well-ventilated area with the engine stopped. Do not smoke or
allow flames or sparks in the area where the engine is refueled or where
gasoline is stored.
•
Do not overfill the fuel tank. After refueling, make sure the tank cap is closed
properly and securely.
•
Be careful not to spill fuel when refueling. Spilled fuel or fuel vapor may ignite.
If any fuel is spilled, make sure the area is dry before starting the engine.
•
Avoid repeated or prolonged contact with skin or breathing of vapor.
Figure 8
ASSEMBLY
Adding Fuel
Use extreme care when handling gasoline. Gasoline is extremely
flammable and the vapors are explosive. Never fuel the riding mower
indoors or while the engine is hot or running. Extinguish cigarettes, cigars,
pipes and other sources of ignition.
1.
Be sure engine is outdoors and in a well-ventilated area.
2.
Clean area around the fuel fill cap and remove the fuel fill cap.
3.
Using an approved red GASOLINE container, add fuel slowly, being careful to
avoid spilling.
4.
Fill the tank until the fuel reaches the bottom of the fuel tank neck.
5.
Replace the fuel cap and tighten securely. Wipe up spilled fuel before
starting engine. If fuel is spilled DO NOT start engine. Move riding mower
away from area of spillage. Avoid creating any source of ignition until fuel
vapors are gone.
Checking and Adding Oil
Your riding mower is shipped with oil in the engine. However, you MUST check
the oil level before operating. Check and add the oil as instructed in your Engine
Operator's Manual.
11
WARNING
Publicidad
