Cleaning The Sensors - NateoSante EOLIS 600 Manual De Utilización

cleAning the Air mAnAger
Clean your unit with a soft cloth that is slightly damp to remove dust. Make sure to follow the safety instructions (see
p.17).

cleAning the SenSorS

Your air manager has 2 sensors: one particle sensor and one VOC (Volatile Organic Compounds) sensor.
these 2 sensors measure air quality in real time. For optimal operation, it is necessary to clean these sensors
at least once per month.
• turn off your unit.
• Open the front cover. the sensors are located above the filters, under the flap.
• Using a damp cotton bud, clean the sensors gently and then let them dry.
• Close the front cover. Make sure the front cover is positioned correctly, to ensure that your unit
will operate correctly. Your unit is ready to operate again.
troUbleShooting help
problem(s)
the unit is no longer operating.
the unit will not turn off
You feel cool air coming from your
unit
the error symbol appears on the
main screen
I can't activate the UV lamp(s) and/or
the Ozone feature
My unit changes fan speeds
I activated Active mode, and the
device is showing an abnormally
high level of pollution (PM2.5 and/
or VOC), but the air purifier is not
continually operating at maximum
speed
I changed the filters, but the unit is
not detecting them
this message appears
"hold down for 3s"
24 - EOLIS Air Manager 600 600 S 1200 1200 S
Solution(s)
- Check the power plug
- Make sure the front cover was closed correctly
- Your filters may be saturated: make sure the "Pending filter change" mes-
sage does not appear in "Errors"
- Make sure the Planner is not set to OFF for a certain amount of time (Set-
tings - Planner ON/OFF).
- Unplug your unit and wait a few minutes before turning it back on
- Make sure that Demo Mode is not active (Settings - Demo Mode ON/OFF)
Cool air from the ground level is drawn up, filtered, and then propelled out.
this can make the air feel cool.
An irregularity has been detected by EOLIS Air Manager. Click on the sym-
bol to display more details.
UV lamp(s) come in models EOLIS Air Manager 600, 600 S, 1200, 1200 S.
Ozone comes in models 600 S and 1200 S.
- Make sure that Active Mode is not on (smart mode)
- Make sure you have not programmed Active Mode or a set fan speed in the
planner
In Active mode, EOLIS Air Manager adapts its speed to the level of pollution.
If the level of pollution is high, EOLIS Air Manager will go up to maximum
speed. however, if the level persists, it will systematically reduce its speed
regularly for your acoustic comfort.
Open the front cover to run an immediate filter test. Wait for the message
"Door open. New filter?" and confirm. You can now close the front cover.
Make sure that the new filters are NatéoSanté certified.
explanations / Actions
this message appears when you have pressed on the following icons: Night
mode, Childproof, On/Off. to activate these features, hold down the icon for
3 seconds.