NateoSante EOLIS 600 Manual De Utilización página 25

"Pin code (digits from 0 to 9)"
"Filter test in progress"
"Plan to change filters"
"Purifier OFF. Pending filter change"
"Door open"
"Cover open. New filter?"
"Cover open. Sensor cleaning?"
"Pending filter change"
"Clean sensors"
"Activate photocatalysis"
"Purifier too small or local airtight-
ness problem"
"Ozone treatment for 1 hour
Leave the room
Starting in 30s"
"Ozone treatment for 1 hour
Leave the room
End in X min"
"temperature sensor out of order"
"VOC sensor out of order"
"Particle sensor out of order"
"Pressure sensor out of order"
"Smart noise activated"
(Only in ACtIVE mode)
"Ventilator jammed or no filer"
"UV lamp out of order"
25 - EOLIS Air Manager 600 600 S 1200 1200 S
If this message appears, it means that you previously selected a pin code in
the Security setting. Just enter your selected pin code. If you have forgotten
it, try these codes: 1234, 4683, 3598 or 7169.
A filter test is carried out every 72 hours of operation (around 3:00 p.m.).
When you open the front cover, EOLIS Air Manager conducts a quick filter
test to analyse their status of wear.
Your filters are reaching saturation (80%) and must be changed quickly
(think about ordering filters in advance from your dealer).
Your filters are 100% saturated, and the unit will resume operation when
you have changed the filters.
If the front cover/door of the device is not shut correctly, the unit will not
operate correctly. Make sure to close the cover correctly.
When you open the front cover, your air purifier may ask you if you have
changed the filter. If so, you can confirm, and if not, press on the cross.
When you open the front cover, your air purifier may ask you if you have
cleaned the sensors (only if sensor cleaning was required). If so, you can
confirm, and if not, press on the cross.
Your unit needs new filters to operate correctly. Change the filters and turn
the unit back on.
the PM2.5 and VOC sensors require regular maintenance (see p.24)
If VOC levels are abnormally high, EOLIS Air Manager will tell you to acti-
vate photocatalysis to reduce VOC levels present in the air.
If this message appears in Errors, your air purifier might be too small for
your room's surface area. Also make sure that no exterior doors or windows
are open.
When you activate OZONE Mode 2, you must leave the room for 1 hour.
Once mode 2 is activated, you have 30 seconds to leave the room.
When you activate OZONE Mode 2, you must leave the room for 1 hour.
If this message appears in the Errors category, make sure your unit is
plugged in or contact your dealer.
If this message appears in the Errors category, make sure your unit is
plugged in or contact your dealer.
If this message appears in the Errors category, make sure your unit is
plugged in or contact your dealer.
If this message appears in the Errors category, make sure your unit is
plugged in or contact your dealer.
EOLIS Air Manager has detected a high level of pollution. If after 30 min-
utes, the level of pollution remains, your air purifier will go down to a lower
speed to not be too loud, and then will operate at a higher speed again when
required by the air quality.
- Make sure that the doors and windows of your home are closed correctly
- Make sure that your device is not too small (placed in a room larger than
one it can purify)
If the filter is missing, put it back in the unit. If the filter is in the unit, please
contact your dealer.
this message appears when one or both UV lamps are no longer working.
Simply replace the defective lamp(s).