Publicidad
Idiomas disponibles
Idiomas disponibles
GB
V. Operation
1. Fast shortening of load chain:
Turn change lever in central position and handwheel clockwise; or set control lever to
LOWER. The brake is opened by fitful left-hand rotation of hand lever. Set control lever to
N and pull through chain with little manual force
Lift/Pull/Clamp
2. For Lifting/Pulling/Clamping tighten load chain and set control lever to Lift, for lowering
(or loosening during clamping) of load set control lever to LOWER.
3. Operation by settled, continuous pump movements of device lever.
4. Brake closes independently when hanging on the minimal load (appr. 10% of nominal
load).
5. Chain block is only suitable for vertical lifting and lowering.
6. To move the load the hand chain is pulled up or down respectively.
VI. Chains and clamps
1. The chains and clamps have to be inspected continuously! Clean chain before
inspection. Lubricate load chain from time to time a bit! Never lubricate or grease the
brake!
2. Retracted chain shall not click under load.
3. Check chain for tension! The internal length (t) of a worn chain link, smallest diameter
of wire (D) and length of 11 chain links (a) are measured by a slide gage where the chain
must be tightened firmly.
4. Dimensions: If the deviations of measurement exceed the values (a) in the following
table substitute chain immediately. Measure of diameter (D) shall not be under-run and
the splitting (t) of the single link not be exceeded.
CE - Declaration of Conformity
We, PLANETA-Hebetechnik GmbH hereby declare under our sole
responsibility that the product:
Chain Hoist PLM-NE and Lever hoist PLX-NE
in serial production correspond with the following rules of directive:
EC-machine dirctive 2006/42/EC
Dipl.-Ing. Paul H. Klawitter, PLANETA
General Manager
- 12 -
Publicidad
