Auger Calibration; Smoke Extractor Calibration; Menu 2. Heating Manage; Boiler Thermostat - BOREAL HYDROBOREAL Serie Instrucciones De Instalación, Uso Y Mantenimiento

9.8.1.2.

AUGER CALIBRATION

You can increase or decrease the fixed value with the keys
that each value you modify is equivalent to modify proportionally 2% each power the value of loading time (seconds) assigned to the auger motor. The
EN
selected value should be confirmed with the key
Consider that as more pellets we load the more power the boiler provides and more consume of combustible. In case you see the stove does not burn
properly or the mix combustible/air is not the right one try with this loading parameter.
9.8.1.3.

SMOKE EXTRACTOR CALIBRATION

You can increase or decrease the fixed value with the keys
0 and the range is between -7 to +7. Consider that each value you modify is equivalent to modify
proportionally 5% each power the value of fan speed (rpm) assigned to the smoke extractor. The
selected value should be confirmed with the key
Consider that as more smoke extractor speed the more smoke extraction we have but also the more
air inlet in the combustion chamber (larger flame). In case you see the stove does not burn properly
or the mix combustible/air is not the right one try with this loading parameter.
9.8.2.

MENU 2. HEATING MANAGE

This menu manages the combustion parameters. It has different submenus:
9.8.2.1.

BOILER THERMOSTAT

This menu allows to select the water temperature in the boiler. You can select between 40º and 80º
C, that is to say the temperature you want your boiler to reach.
The selected value should be confirmed with the key
When the water temperature of the boiler reaches the requested value by the user, the boiler starts
mode "stand by", i.e. starts modulation lowing the power to adequate to the selected temperature
of the water and keep on working. In this case it is possible that your house do not reach the
temperature requested from the external thermostat because the water temperature value that you
have fixed is low for your comfort temperature. We recommend putting an enough temperature
value (70-75º) to allow the boiler keep on working and reach your house comfort temperature
9.8.2.2.

PUFFER TANK TEMPERATURE

This menu allows selecting the temperature in the puffer tank. In case you do not want to use your
boiler to produce sanitary water you should skip this menu. You can select between 40º and 55º C,
that is to say the temperature you want your boiler to reach. The selected value should be confirmed
with the key before going out of the menu.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
or . The fixed value from factory is 0 and the range is between -7 to +7. Consider
before going out of the menu.
Settings
Auger Calibration
0
Min: -7 Max: 7
or . The fixed value from factory is
before going out of the menu.
before going out of the menu.
56
Settings
Fan Calibration
0
Min: -7 Max: 7
Settings
Boiler Thermostat
75
Min: 40 Max: 80
Settings
Buffer Thermostat
45
Min: 40 Max: 55
HYDROBOREAL