The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the do-
mestic power supply socket is not earthed, connect the
appliance to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
• Loosen the upper pin
and remove the spacer.
• Remove the upper pin
and the upper door.
Ventilation requirements
The airflow behind the ap-
pliance must be sufficient.
• Loosen the middle
hinge.
min.
50 mm
200 cm
2
min.
2
200 cm
This appliance complies with the E.E.C. Directives.
Door reversibility
The door of the appliance opens to the right. If you want to
open the door to the left, do these steps before you install
the appliance:
• Remove the lower door.
• Loosen the lower pin.
Installing the appliance
Caution! Make sure that the mains cable can move
freely.
Do the following steps:
On the opposite side:
• Install the lower pin.
• Install the lower door.
• Tighten the middle
hinge.
• Install the upper door.
• Tighten the spacer and
tighten the upper pin.
23