Identification Data; Using The Appliance For The First Time - ARIETE 2894 Manual De Instrucciones

17 - Power cord + Plug
18 - Reference on the cover
19 - Lid opening position
20 - Filter holder with filter extraction position
21 - Lid closing position

Identification data

The label under the power base shows the following identification data of the appliance:
• manufacturer and CE mark
• model (Mod.)
• serial number (SN)
Always give the model and serial number to the Authorised Service Centres when requesting assistance.
prelImInAry phAses For use

using the appliance for the first time

Before connecting the appliance to the mains check that the voltage indicated on the label under the power
base matches with the local mains. Place the appliance on a horizontal and stable surface.
Warning!
Do not place the appliance or power cord close to or on top of hot electric or gas cookers, or close to
a microwave oven.
Prevent the cord from protruding beyond the edge of the table or surface. Prevent children from grab-
bing the cord, in this way tipping over the appliance.
If the power cord is too long, wrap it under the power supply base (Fig. 3). The cable must not touch
the hot parts of the appliance.
Position the appliance so that children cannot reach the hot parts.
InsTrucTIons For use
Warning!
The water filling and emptying operations must be carried out with the jug separated from the power
base.
Do not use the jug without water.
Boil the water the first time the appliance is turned on. drain and rinse the jug. repeat the operation
two or three times.
Remove the jug from the power supply base. Rotate the lid in the filter holder extraction position (20). Remove
the filter holder from the jug (Fig. 5). Fill the jug with fresh plain water to the desired level (Fig. 6). The level
should never be less than two cups (Fig. 7).
do not exceed the level indicated by maX: danger of leakage of hot water from the jug.
Turn the lid in position (X19). Remove the lid and extract the tea filter (Fig. 8). Place the desired amount of tea
in the filter. Place the tea filter in the filter holder. Place the filter holder into the jug. Close the lid and rotate it
to align the reference with the closing symbol (21). Place the jug on the power base (2).
Insert the plug into the socket, which must be earthed. You will hear two beeps. Press the infusion start/delete
button (11). The display shows the last temperature set. If you do not press any button, after 30 seconds the
appliance turns off.
10
• electrical supply voltage (V) and frequency (Hz)
• absorbed electric power (W)
• assistance toll-free number