Connecting The Power Cable - Dometic eStore Instrucciones De Montaje Y De Uso

Connecting eStore
8.4

Connecting the power cable

A
NOTICE!
 Only connect devices with a rated voltage of 12 Vg.
 Pay attention to the correct polarity when connecting devices
to eStore. Please refer to the respective manual.
 Make sure that the devices you want to connect are turned off.
➤ Turn off (open) the main switch of eStore one by pressing the main switch
command (fig. 1 1, page 3).
➤ Open the cover (see chapter "Opening the cover of the pole" on page 17) .
➤ Connect the positive cable to the positive pole (fig. 2 3, page 3).
➤ Tighten the terminal screw with a tightening torque of 13 to 15 Nm.
➤ Close the cover (see chapter "Closing the cover of the pole" on page 17.
➤ Open the cover of the negative pole (see chapter "Opening the cover of
the pole" on page 17) .
➤ Connect the negative cable to the negative pole (fig. 2 1, page 3).
➤ Tighten the terminal screw with a tightening torque of 13 to 15 Nm.
➤ Close the cover of the negative pole (see chapter "Closing the cover of
the pole" on page 17).
➤ Turn on (close) the main switch of the eStore by pressing the main switch
command (fig. 1 1, page 3).
8.5 Connecting consumers
➤ Turn off all devices, especially those that are connected with eStore.
➤ Turn off (open) the main switch of eStore one by pressing the main switch
command (fig. 1 1, page 3).
➤ Connect the 12 Vg device to eStore.
➤ Turn on (close) the main switch of the eStore by pressing the main switch
command (fig. 1 1, page 3).
➤ Turn on the 12 Vg device.
18
eStore
EN