Ruwido digital_2 Instrucciones De Uso página 16

GB
Automatic programming the TV set according to brand
As an alternative, and if the correct code for your TV set cannot be found for manual
programming, you can use the automatic search function by brand for programming.
1) Switch your TV set on.
2) Look up the brand of your TV set in the brand list in the appendix to this instruction
manual. There is a 3-digit brand code for each brand.
3) Press and hold the TV Standby button (
4) Use the number buttons to enter the code
twice to confi rm that the search mode has been activated.
5) Use the number keys to enter the three-digit brand code from the brand list for the
brand that you have selected. The signal LED ( ) fl ashes twice to indicate that the
code has been accepted.
6) Hold down the TV Standby button (
off. This process can take several minutes.
7) As soon as the unit has switched off, push the OK button to confi rm the
programming (
8) Test the functionality of your remote control using the TV standby button (
the AV button (
correctly programmed and can be used.
Note
several codes to which your TV set responds, but where all buttons do not function
for each code. In this case, the search process should be re-started (steps 3 to 9)
until you obtain the best code. Re-starting the search process starts at the last
saved programming.
BA digital_2 RC10120 Innenteil, V1, 105x210 mm, 1c CS4.indd 16 BA digital_2 RC10120 Innenteil, V1, 105x210 mm, 1c CS4.indd 16
OPERATING INSTRUCTIONS
ruwido digital_2 universal remote control
) until the Signal LED ( ) fl ashes twice.
ok
). If the TV set responds properly to all functions, your digital_2 is
av
: It could happen, that during the search process, the digital_2 fi nds
) until the signal LED ( ) fl ashes twice.
tv
. The Signal LED ( ) fl ashes
1 0 0 3
) on your digital_2 until the TV set switches
tv
16
) and
tv
19.01.2011 12:29:38 19.01.2011 12:29:38