Ruwido digital_2 Instrucciones De Uso página 17

GB
Automatic programming of the satellite receiver and the DVB-T
(Freeview)/cable-box (STB) according to brand
As an alternative, and if the correct code for your unit cannot be found for manual
programming, you can use the automatic search function by brand for programming.
1) Switch your satellite receiver or DVB-T (Freeview)/cable-box (STB) and TV set on.
2) Look up the brand of your unit in the brand list in the appendix to this instruction
manual. There is a 3-digit brand code for each brand.
3) Press and hold the STB Standby button (
twice.
4) Use the number buttons to enter the code
twice to confi rm that the search mode has been activated.
5) Use the number keys to enter the three-digit brand code from the brand list for the
brand that you have selected. The signal LED ( ) fl ashes twice to indicate that the
code has been accepted.
6) Hold down the Standby button ( ) on your digital_2 until the unit switches off. This
process can take several minutes.
7) As soon as the unit has switched off, push the OK button to confi rm the
programming (
8) Now test the individual buttons on your remote control for function, starting with the
STB Standby button (
buttons 1 to 21 (in accordance with functional description table). The AV button (
and TV Standby button (
9) If the unit responds properly to all functions, your digital_2 is correctly programmed
and can be used.
Note
several codes to which your unit responds, but where all buttons do not function for
each code. In this case, the search process should be re-started (steps 3 to 9) until
you obtain the best code. Re-starting the search process starts at the last saved
programming.
BA digital_2 RC10120 Innenteil, V1, 105x210 mm, 1c CS4.indd 17 BA digital_2 RC10120 Innenteil, V1, 105x210 mm, 1c CS4.indd 17
OPERATING INSTRUCTIONS
ruwido digital_2 universal remote control
ok ) until the Signal LED ( ) fl ashes twice.
), volume buttons (volume
stb
) are not tested.
tv
: It could happen, that during the search process, the digital_2 fi nds
) until the signal LED ( ) fl ashes
stb
. The Signal LED ( ) fl ashes
3 0 0 3
/ ), and then with the
17
)
av
19.01.2011 12:29:41 19.01.2011 12:29:41