Setting The Receivable Signal Types - JVC GM-P420E Manual De Instrucciones

Video Adjustments
2 / 3 5 /
DISPLAY ASPECT
VIDEO A
MUTING
MENU/EXIT
MENU/EXIT
1
* "PICTURE MODE" and "SIGNAL MODE" do not
appear at the same time.
"PICTURE MODE" appears when RGB input (either
RGB A or RGB B) is selected, and one of the following
signals comes in — RGB15K-50, RGB15K-60, and
VGA480-60. On the other hand, "SIGNAL MODE"
appears when VIDEO A, VIDEO B, or COMPONENT
input is selected.
2
* "RGB/COMPO." appears only when the RGB B or
COMPONENT input is selected.
22
(Continued)
MENU INPUT POWER
MENU INPUT POWER
MENU
POWER
VIDEO B COMPO. RGB A
RGB B
VOLUME
RM-C576 REMOTE CONTROL UNIT

Setting the Receivable Signal Types

You can set the receivable signal types. Normally, select
"AUTO."
A common setting will apply to both the VIDEO A input and
the VIDEO B input, and a different setting will apply to the
COMPONENT input.
1
Press MENU/EXIT (or MENU on the
Monitor) to display the Main Menu.
Cursor (3)
2
Press 5/∞ to move the cursor (3) to
"FUNCTION SELECT."
3
Press 3 to display the Function
Selection Menu.
4
Press 5/∞ to move the cursor (3) to
"SIGNAL MODE."
5
Press 2/3 to select the receivable video
signal type.
Each time you press the button, the receivable video
2 / 3
signal type changes as follows:
5 /
• When VIDEO A or VIDEO B input is selected:
AUTO
PAL60
• When COMPONENT input is selected:
AUTO
1080i
(1035i)*
* Changes according to the "HD SIGNAL MODE"
setting (see page 27).
6
Press MENU/EXIT (or MENU on the
Monitor) twice to exit the menu
operations.
M A I N M E N U
P I C T U R E A D J .
S I Z E / P O S I T I O N A D J .
F U N C T I O N S E L E C T
S T A T U S D I S P L A Y
E N T E R : S E L E C T : E X I T :
M E N U
F U N C T I O N S E L E C T
C O L O R T E M P . : H I G H
*
P I C T U R E M O D E : S T I L L
A S P E C T : P A N O R A M I C
S I G N A L M O D E : A U T O
R G B / C O M P O . : C O M P O .
r e s e t
A D J U S T : S E L E C T : E X I T : M E N U
NTSC
PAL
N4.43 SECAM
(NTSC4.43)
480i 576i
720p 480p
1
*
2
*