Safety Measures; Operating Instructions - KVT-Fastening FASTSET 6 Manual De Instrucciones

FASTSET 6
EN

SAFETY MEASURES

• Use the riveting tool properly and for the purposes for which it has been manufactured.
• Any kind of modification made on the riveting tool and its equipment by the customer itself, will
be done under the fully responsibility of the customer. In this case, KVT-Fastening declines any
responsibility.
• The riveting tool must be always kept in safety conditions and must be revised at periodically by
expert and authorized workers, following the maintenance instructions of KVT-Fastening.
• The riveting tool will always be used following the EC normative "on health and safety measures
on job" (Directive 2006/42/EC). If you need some information regarding the correct operating of
the tool, please contact to KVT-Fastening.
• The safety precautions necessary for the use of this device must be explained to the operator
by the customer in detail. Always detach the air feeding from the take-off point of the tool before
regulating, repairing and cleaning operations.
• Don't use the tool if is turned towards other persons.
• Operating pressure have not to exceed 7 bar - 100 LBF/IN
• Make sure that the air discharges are not blocked or covered and the feeding hoses are always in
good working conditions.
• The operations of maintenance, repairing and cleaning must be done when the tool is not connected
to the air.
• When using the riveting tool, wear protective glasses or visors and gloves.
• Use only original spare parts for repairing and maintenance. KVT-Fastening declines any responsibility
for any kind of damages caused by not observing the above and following instructions (directive
CEE 85/734).
• If the noise level is over the safety limit of 85 dB (A), use the proper hearing protections (antinoise
headset etc.).

OPERATING INSTRUCTIONS

Air feed
All the tools works with compressed air, with a pressure of 6 bar.
We suggest to use regulators of pressure and automatic filtering systems on the main net of feeding air.
These will have to stay max 3 meters of distance from the tool (see the drawing), in order to assure an
optimal pressure in the tool and its maximum duration-life with a minimum maintenance.
The flexible tubes for the air compressed in entrance must be in a position to supporting a pressure
of 10 bars and will have to be resistant to the oil, covered of a material resistant to the abrasions and
protected in case bad job conditions could damage them.
All the flexible tubes for the compressed air must have a diameter of minimum passage of 6,4 mm or
/ of inch.
1
4
The pressure regulator must be set up to 6,5 bars in consideration of the pressure fall.
32 | 64
.
2
REV | 03