Cleaning and caring for the converter
✓ The LEDs (fig. 1 3 to 5, page 3) indicate the operating status:
LED
Power On
Battery Low
Overload
I
NOTE
The internal fan is operated according to the temperature. It only
runs when the temperature is too high. During this time the con-
verter is switched off to prevent overheating.
8
Cleaning and caring for the converter
!
WARNING! Danger of electrocution!
Always disconnect the mains plug before you clean and service
the device.
A
NOTICE! Danger of damaging the device!
Never clean the device under running water or in dish water.
Do not use abrasive cleaning agents or hard objects during clean-
ing as these can damage the device.
➤ Occasionally clean the device with a damp cloth.
32
Colour
Explanation
Green
The device is switched on and there is volt-
age at the output terminals on the con-
verter. The converter is ready for use.
Yellow
The input battery is no longer sufficiently
charged.
➤ Recharge the battery or use a charged
Red
If a consumer is connected:
The converter is shorted or overloaded.
➤ Eliminate the short circuit or reduce the
If connected as a charger:
The converter is in the full current charging
phase.
PerfectCharge/PerfectPower
battery.
output load.
EN