Mounting The Converter; Mounting Instructions; Using The Converter - Dometic PerfectCharge DC08 Instrucciones De Montaje

Mounting the converter

6 Mounting the converter
6.1

Mounting instructions

If you wish to mount the converter in a fixed position, please observe the fol-
lowing mounting instructions:
 You can mount the device either horizontally or vertically.
 Do not mount the device
– In wet or damp environments
– In the vicinity of combustible materials
– In areas where there is a danger of explosions
 The place of installation must be well-ventilated. A ventilation system
must be present for installations in small, closed spaces. The minimum
clearance around the device must be at least 5 cm (fig. 2, page 3).
 The air intake on the underside or the air outlet on the back of the device
must remain clear.
 For ambient temperatures higher than 40 °C (such as in engine or heating
compartments, or direct sunlight), the heat from the device under load can
lead to the automatic shut-down.
 The installation surface must be level and sufficiently sturdy.
A
NOTICE!
Before drilling any holes, ensure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
6.2 Mounting the converter
➤ Hold the converter against the installation location and mark the fastening
points (fig. 3 A, page 3).
➤ Fasten the converter using your chosen method (fig. 3 B, page 3).
7

Using the converter

Connecting the input battery
!
WARNING!
Do not reverse the polarity. Reverse polarity of the battery con-
nections can cause injury and irreversably damage the device.
30
PerfectCharge/PerfectPower
EN