Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Please use the correct power source.
!
Caution
Please make sure the water inlet pipe
is connected and the tap is open
before washing.
!
User is not allowed to change the
power cord or plug.
Prohibited
Please do not pull the power cord,
pull the plug.
!
Please do not pull out or insert the
power plug with wet hands to avoid
electric shock.
Wet hands prohibited.
The water temperature shall not exceed
55℃ when washing with
warm water.
Prohibited
It is strictly prohibited to place or sit
children or place
weight on top of
the washer.
Prohibited
Please do not wash raincoats,
fishing coats or similar clothes
in the washer.
Prohibited
6
Washer Installation
Remove Package
! Remove package and take out the bottom board of the
cabinet on the foam cover.
! Open the washer's lid and take out accessories.
! A trial operation or washing with the foam cushion is
strictly forbidden.
Upper Drain Hose Placement
Drain hose height ("a") should be between 86 and 100cm.
Diameter of ("b") should be not less than 3 cm, and flow
capacity not less than 40 L/Min.
Before the washer starts, user should hang up the drain
pipe at 86-100cm from the floor.
FOR UPPER SYSTEM DRAIN ONLY
Water Inlet Pipe Installation
Screw the water inlet pipe (it has a metallic
filter bag) to the tap.
Tightly screw the other end of the water inlet hose
on water inlet valve. (with the rubber seal ring inside).
Note: When tightening the clamping nut,
apply force evenly and do not twist the
water inlet valve to avoid breaking the
water inlet valve joint.
Water inlet hose
Clamping nut
Base foamed cushi o n
Clamping nut
Water inlet hose
Only for models with double
screw thread water inlet pipe.
7
Publicidad
Capítulos
Tabla de contenido
